1 5.0556

A TSMC 28nm 1.8V-3.3V Fail-Safe General-Purpose IO & OSC This 28nm GPIO is designed for high-speed (>150MHz output, >250MHz input) applications. The IO operates at either 1.8V or 3.3V and can dynamically sw...

2 5.0556

A radiation-hardened 130nm Wirebond IO library with 3.3V GPIO, LVDS TX & RX, 3.3V I2C open-drain, analog cell and OTP program cell Key attributes of the 130nm IO library include an extended operational temperature range (-55°C to 200°C), sleep retention, and a built-in power regul...

3 4.0556

RGMII I/O offerings Certus is pleased to offer Reduced Gigabit Media Independent Interface (RGMII) compliant IOs in advanced technology nodes. The Certus solutions suppo...

4 4.0556

Secure Digital I/O offerings Certus is pleased to offer Secure Digital compliant IOs in advanced technology nodes. Our SD IOs support DS, HS, SDR25, SDR50, DDR50 and SDR104 prot...

5 0.0

Bi-Directional LVDS with LVCMOS BiDirectional LVDS IO circuit combines LVDS driver and receiver circuits to enable a single pair of IO pads to function as a 1.5Gbps bi-directional LV...

6 0.0

Wide-range LVDS Video Interface Flexible video deserializer capable of receiving 18bit, 24bit, and 30bit video data with embedded sync and control carried over four or five serial LV...

7 5.0

DDR4IO for memory PHY, 3200Mbps The DDR4 IO is used to transfer the Command/Address/Clk and Data between the memory controller PHY and the DRAM device. The TX is designed to send inf...

8 20.0

NVM FTP Trim in SMIC (180nm, 110nm) Synopsys Non-Volatile Memory (NVM) IP provides reprogrammable NVM supporting up to 1 million bits (1Mbit) configurations in standard CMOS and BCD proc...

9 20.0

NVM FTP Trim in TowerJazz (180nm) Synopsys Non-Volatile Memory (NVM) IP provides reprogrammable NVM supporting up to 1 million bits (1Mbit) configurations in standard CMOS and BCD proc...

10 25.0

Duet Package of Embedded Memories and Logic Libraries for UMC (40nm, 28nm) The Synopsys Duet Packages of Embedded Memories and Logic Libraries, part of Synopsys Foundation IP portfolio, offer an integrated portfolio of standa...

11 3.0

12 track thick oxide standard cell library at TSMC 40 - low leakage and direct battery connection (operating voltages from 1.1 V to 3.3 V) SESAME BiV 40 uLP a new thick oxyde based standard cell library for ultra low leakage logic design and/or direct battery connection through the use o...

12 2.0

ONFI 4.1 I/O Pad Set The ONFI 4.1 library provides the combo driver / receiver cells, the ODT / driver impedance calibration cell, and the voltage reference cell to supp...

13 2.0

3.3V 100MHz Oscillator I/O Pad Set The 3.3V 100MHz Oscillators library includes a programmable oscillator macro I/O cell. ▪ 100 MHz programmable oscillator These libraries are off...

14 2.0

1.8V 3.3V Tolerant General Purpose IO The 1.8V GPIO 3VT library provides general purpose bidirectional I/O cells that are both fault tolerant and 3.3V tolerant. These programmable, multi-v...

15 2.0

CI Plus The CI Plus library provides a programmable bi-directional I/O cell designed to meet the signal interface requirements of the Common Interface. This l...

16 2.0

3.3V Wide-Range General Purpose Staggered I/O Pad Set The 3.3V General Purpose I/O library provides bidirectional I/O, isolated analog I/O, and a full complement of power cells along with corner and spa...

17 2.0

1.8V General Purpose I/O Inline Pad Set The 1.8V General Purpose I/O library provides bidirectional I/O, isolated analog I/O, and a full complement of power cells along with corner and spa...

18 2.0

3.3V Wide-Range General Purpose I/O Pad Set The 3.3V General Purpose I/O library provides bidirectional I/O, isolated analog I/O, and a full complement of power cells along with corner and spa...

19 2.0

subLVDS I/O Pad Set The subLVDS library provides a subLVDS driver, receiver, and temperature stable voltage reference capable of supporting 16 drivers operating at data...

20 2.0

SSTL_15 / SSTL_18 Combo I/O Pad Set The SSTL_15_18 combo pad set supports bidirectional single-ended and differential SSTL_15 and SSTL_18 signaling. The driver/receiver pairs, with embe...

21 2.0

SSTL_15 IO Pad Set The SSTL_15 pad set supports bidirectional single-ended and differential SSTL_15 signaling. The driver/receiver pairs, with embedded power cells, ar...

22 3.0

12 track thick oxide standard cell library at TSMC 40 - low leakage and direct battery connection (operating voltages from 1.1 V to 3.3 V) SESAME BiV 40 uLPeFlash a new thick oxyde based standard cell library for ultra low leakage logic design and/or direct battery connection through the...

23 2.0

3.3V 32 KHz RTC and Programmable 100MHz Oscillator I/O Pad Set The Oscillator library provides oscillators for on-chip asynchronous clock generation with an appropriate external crystal. This library is provided...

24 2.0

LVDS I/O Pad Set The LVDS library provides an LVDS driver, receiver, and temperature stable voltage reference capable of supporting 16 drivers operating at data rate...

25 2.0

1.8V GPIO: 3.3V Tolerant The 1.8V Fault-Tolerant General Purpose I/O library provides a 3.3V tolerant programmable, bidirectional I/O that give the system designer the flexibi...

26 2.0

ICC I/O Pad Set The ICC library provides the bidirectional reset, clock, and data I/O drivers for the smart card UICC terminal interface. This library has been desi...

27 2.0

3.3V Wide-Range General Purpose I/O Pad Set The 3.3V General Purpose I/O library provides bidirectional I/O, analog I/O, and a full complement of I/O power, core power, and analog power cells al...

28 2.0

2.5V Wide-Range General Purpose I/O Pad Set The 2.5V General Purpose I/O library provides bidirectional I/O, isolated analog I/O, and a full complement of power cells along with corner and spa...

29 2.0

5V Programmable GPIO The 5V General Purpose I/O libraries provide bidirectional I/O, analog I/O, and a full complement of I/O power, core power, and analog power cells alo...

30 2.0

RF I/O Pad Set and Discrete RF ESD Protection Components The RF libraries include analog signal pads and ESD protection components for RF applications. These libraries are offered as a supplement to the stan...

31 2.0

USB 2.0 OTG ESD Protection I/O Pad Set The USB 2.0 OTG ESD Protection library provides a comprehensive ESD solution for USB 2.0 hard macro cells....

32 2.0

3.3V 32kHz RTC, 50MHz Low Power Oscillator, and Programmable 100MHz Oscillator Pad Set The Oscillators library provides oscillators for on-chip asynchronous clock generation with an appropriate external crystal. This library is offered a...

33 3.0

Dual Port SRAM compiler - Memory optimized for high density and low power - Dual Rail - compiler range up to 288 k Dual Port SRAM compiler - TSMC 40 nm uLP - Memory optimized for high density and low power - Dual Rail - compiler range up to 288 k...

34 2.0

LVDS I/O Pad Set The LVDS library provides an LVDS driver, receiver, and temperature stable voltage reference capable of supporting 16 drivers operating at data rates ...

35 2.0

ONFI_4 IO Pad Set The ONFI 4.1 library provides the combo driver / receiver cells, the ODT / driver impedance calibration cell, and the voltage reference cell to suppor...

36 2.0

SD 3.0 I/O Pad Set The SD library provides the driver / receiver cell for SD 3.0 signaling. The library is compliant with the SD Specifications, Part 1, Physical Layer S...

37 2.0

CML I/O Pad Set The CML library provides a differential clock driver, a voltage reference, and power cells to support REFCLK signaling for PCIe applications....

38 2.0

I2C I/O Pad Set The I2C libraries provide the bidirectional I/O for two-line serial communication per Rev. 4 of the I2Cbus industry specification. The design is compa...

39 2.0

3.3V GPIO: Fault Tolerant The 3.3V Fault-Tolerant General Purpose I/O libraries provide programmable, multi-voltage bidirectional I/O’s that give the system designer the flexib...

40 2.0

1.8V Programmable 100MHz Oscillator I/O Pad Set The Oscillators library provides a programmable oscillator for on-chip asynchronous clock generation with an appropriate external crystal. This oscil...

41 2.0

7 way DDR combo The LPDDR2/3_DDR3/4 libraries contain the 7-way combo driver/receiver cells with embedded power cells, the driver impedance calibration cell, and the ...

42 2.0

CML I/O Pad Set The CML library provides a differential current mode logic clock driver to support REFCLK signaling in PCIe applications along with a CML voltage refe...

43 2.0

I2C I/O Pad Set The I2C library provides open-drain bi-directional I/O cells designed for the I2C two-line interface. It is compliant with the I2C-bus specification –...

44 0.0

6 track High Density standard cell library at TSMC 180 nm TSMC 180 G, SESAME HD provides the best trade-off between area and power achieved from an innovative cell design enabling 6-track cells....

45 2.0

1.8V Power Support I/O Pad Set The 1.8V Support: Power library provides a full complement of cells to support the assembly of a complete pad ring by abutment. It is supplied as a st...

46 2.0

1.8V Programmable 100MHz Oscillator I/O Pad Set The Oscillators library provides a programmable oscillator for on-chip asynchronous clock generation with an appropriate external crystal. This oscil...

47 2.0

3.3V 100 MHz Oscillator I/O Pad Set The 1.8V General Purpose I/O library provides bidirectional I/O, isolated analog I/O, and a full complement of power cells along with corner and spa...

48 2.0

3.3V Power Support I/O Pad Set The 3.3V Support: Power library provides a full complement of cells to support the assembly of a complete pad ring by abutment. It is supplied as a st...

49 2.0

ESD Protection The ESD Protection library provides ESD protection components. In addition to core-placeable ESD protection cells, discrete components (RF diodes and ...

50 2.0

I2C IO Pad Set The I2C library provides open-drain bi-directional I/O cells designed for the I2C two-line interface. It is compliant with the I2C-bus specification –...