English
You are here:
APB Pulse Width Modulator (70129)
The APB PWM Module is a standard APB peripheral that generates a programmable duty cycle output signal. The frequency of the output waveform is either PCLK/256 or PCLK/4096, depending on whether a 4-bit prescaler is enabled. The duty cycle can be programmed with 8-bit resolution from either the APB interface or from an external controller interface. The output can be disabled or enabled. Disabling resets the counter to zero for the next enable.
Features
- 256 and 4096 prescale
- Prescale and non-prescale modes
- 4bit prescaler
- 8bit counter/accumulator
- Strobe and Data input for synchronization
Deliverables
- Verilog Source
- Complete Test Environment
- APB Bus Functional Model
- C-Sample Code
Block Diagram of the APB Pulse Width Modulator (70129) IP Core
View APB Pulse Width Modulator (70129) full description to...
- see the entire APB Pulse Width Modulator (70129) datasheet
- get in contact with APB Pulse Width Modulator (70129) Supplier
PWM
- 105 dB of SNR, 24-bit stereo PDM to PWM transmodulator DAC
- Up to 105 dB of SNR, 24-bit stereo CODEC with PDM to PWM transmodulator DAC and embedded regulator
- Up to 105 dB of SNR, 24-bit stereo CODEC with PDM to PWM transmodulator DAC and embedded regulator
- Low-BoM, inductor-based buck switching regulator with high efficiency, full PWM mode
- 105 dB of SNR, 24-bit stereo PDM to PWM transmodulator DAC
- Up to 105 dB of SNR, 24-bit mono CODEC with PDM to PWM transmodulator DAC and embedded regulator