Design & Reuse
arrow A/D Converter (ADC) (527)
arrow Amplifier (102)
arrow Analog Comparator (21)
arrow Analog Filter (27)
arrow Analog Front Ends (38)
arrow Analog Multiplexer (3)
arrow Analog Subsystems (3)
arrow Clock Synthesizer (83)
arrow Coder/Decoder (CODEC) (107)
arrow D/A Converter (DAC) (221)
arrow DC-DC Converter (63)
arrow DLL (743)
arrow Graphics & Video Modules (5)
arrow Oscillator (337)
arrow Oversampling Modulator (8)
arrow PLL (1715)
arrow Power Management (856)
arrow RF Modules (82)
arrow Sensor (82)
arrow Switched Cap Filter (1)
arrow Temperature Sensor (142)
arrow Other (498)
102 IP
51
1.0
Low noise amplifier with lange couplers for 24-42 GHz frequencies for 5G , satcom and other applications
RFLN06C is a four stage low noise amplifier. It provides high gain over wide bandwidth, low noise figure, high isolation, stability. The LNA is design...
52
1.0
Low Noise Amplifier, 2.36GHz-2.5GHz - GlobalFoundries 130nm RFSOI
Low Noise Amplifier, 2.36GHz-2.5GHz - GlobalFoundries 130nm RFSOI...
53
1.0
Low-Noise Amplifier (Single-ended cascode) - GlobalFoundries 22nm
Low-Noise Amplifier (Single-ended cascode) - GlobalFoundries 22nm...
54
1.0
Power amplifier, 1.8GHz - GlobalFoundries 130nm RFSOI
Power amplifier, 1.8GHz - GlobalFoundries 130nm RFSOI...
55
1.0
Operational amplifier - GlobalFoundries 130nm RFSOI
Operational amplifier - GlobalFoundries 130nm RFSOI...
56
1.0
Operational amplifier - XFAB 180nm
Operational amplifier - XFAB 180nm...
57
1.0
Operational Amplifier for output buffering - GlobalFoundries 40nm
Operational Amplifier for output buffering - GlobalFoundries 40nm...
58
1.0
Driver Amplifier 8-16GHz
...
59
1.0
Driver Amplifier operating from 1-16 GHz and can be used in wide band application or to drive the high-power amplifier
RFDA07C Driver Amplifier operates from 1 - 16 GHz and can be used in wide band application or to drive the high-power amplifier. The amplifier provide...
60
1.0
Driver Amplifier operating from 10 - 24 GHz and can be used in wide band application or to drive the high-power amplifier
RFDA02C Driver Amplifier operates from 10 - 24 GHz and can be used in wide band application or to drive the high-power amplifier. The amplifier provid...
61
1.0
Driver Amplifier operating from 24-30 GHz and can be used in wide band application or to drive the high-power amplifier
RFDA06C Driver Amplifier operates from 24 – 30 GHz and can be used in Ka band application or to drive the high-power amplifier. The amplifier provides...
62
1.0
Driver Amplifier operating from 35 - 39 GHz and can be used in Ka band applications or to drive the high power amplifier
RFDA13C Driver Amplifier operates from 35 - 39 GHz and can be used in Ka band applications or to drive the high power amplifier. The amplifier provide...
63
1.0
Driver Amplifier operating from 35 - 46 GHz and can be used in Ka / V band applications or to drive the high-power amplifier
RFDA12C Driver Amplifier operates from 35 - 46 GHz and can be used in Ka / V band applications or to drive the high-power amplifier. The amplifier pro...
64
1.0
Driver Amplifier operating from 37 - 40 GHz and can be used in Ka band applications or to drive the high-power amplifier.
RFDA11C Driver Amplifier operates from 37 - 40 GHz and can be used in Ka band applications or to drive the high-power amplifier. The amplifier provide...
65
1.0
CSMC 0.13um Generic Process Programmable Gain Amplifier
The CS13V33_PGA_02 integrates two 2-channel programmable gain amplifiers It is always combined with audio ADC or audio DAC to pre-amplify analog input...
66
1.0
Buffer Amplifier operating from 10-45 GHz and can be used in wide band application or to drive the high power amplifier
RFBA02C Buffer Amplifier operates from 10-45 GHz and can be used in wide band application or to drive the high power amplifier. The amplifier provides...
67
1.0
Buffer Amplifier operating from 25-62.5 GHz and can be used in Ka / V band application or to drive the high power amplifier.
RFBA01C Buffer Amplifier operates from 25-62.5 GHz and can be used in Ka / V band application or to drive the high power amplifier. The amplifier prov...
68
1.0
1Watts, 2.1-2.8GHz Power Amplifier
...
69
0.118
An 8-bit 10MSPS Programmable Gain Amplifier ;UMC 55nm SP-HVT LowK Logic Process
An 8-bit 10MSPS Programmable Gain Amplifier ;UMC 55nm SP-HVT LowK Logic Process...
70
0.118
5V 1W Mono Speaker Amplifier, UMC 55nm SP/RVT LowK Logic Process.
5V 1W Mono Speaker Amplifier, UMC 55nm SP/RVT LowK Logic Process....
71
0.0
8 to 12 GHz power amplifier
055TSMC_PA_05 is a block includes a power amplifier (PA), output power adjustment system and supply voltage stabilizer. The PA is designed to provide ...
72
0.0
5 to 20 MHz Intermediate-frequency amplifier
IFA consists of 3-stages amplifier with tunable gain, AGC system, linear output buffer for differential analog output, analog-digital converter for 2...
73
0.0
2 to 27 MHz Intermediate frequency amplifier
IFA consist of 3-stages amplifier with tunable gain, AGC system, linear output buffer for differential analog output, analog-digital converter for dig...
74
0.0
1 to 30 MHz Intermediate-Frequency Amplifier with Wide Gain Range
IFA consists of 3 stages amplifier with tunable gain, AGC system, linear buffer for analog output and an analog-digital converter (ADC) for 2-bits dig...
75
0.0
3 to 5 GHz LNA with 2.8dB NF and 20dB gain
130iHP_LNA_04 consists of two bipolar amplifier stages. The block is used correction circuit for frequency range extension. Amplifier output based on ...
76
0.0
8 to 512 kHz intermediate-frequency amplifier
The device is a t2-channel intermediate-frequency amplifier (IFA). Each channel consists of 1 stage amplifier with differential inputs/outputs, progra...
77
0.0
1.16 to 1.26 and 1.56 to 1.61 GHz low noise amplifier with 27.5dB gain
350AMS_LNA_04 is a common receiver front-end device which is used to provide impedance matching to off-chip circuits and to perform first step low noi...
78
0.0
0.2 to 3 GHz power amplifier
130iHP_PA_03 is based on AB class power amplifier with a preamplifier. The block is designed to set the required output signal and provides a wide ran...
79
0.0
0.8 to 25 MHz Intermediate-frequency amplifier
IFA consists of 4-stage amplifier with tunable gain, AGC system, linear output buffer for differential analog output, analog-digital converter for dig...
80
0.0
60 to 83 MHz High linearity intermediate frequency amplifier
Intermediate-frequency amplifier consists of 2-stages amplifier, output buffer with tunable gain and two LDO voltage regulators. Each stage of the amp...
81
0.0
500-1750MHz LNA with 1dB NF and 19dB gain
055TSMC_LNA_01 is an electronic amplifier intended to amplify a very low power signal without significantly degrading its SNR. The operating frequency...
82
0.0
120 to 250 kHz Intermediate frequency amplifier with AGC
055TSMC_IFA_01 is an intermediate frequency amplifier (IFA) designed to amplify and transmit differential signals in the frequency range from 120kHz t...
83
0.0
1220 to 1610 MHz Low noise amplifier
Low noise amplifier (LNA) is usually used as the first stage of receivers and is characterized by low noise figure and high linearity. LNA is based on...
84
0.0
130 to 930 MHz Low-noise amplifier
Low noise amplifier (LNA) is usually used as the first stage of receivers and is characterized by low noise figure and high linearity. The structure i...
85
0.0
64 dB Intermediate frequency amplifier with wide gain range
Intermediate frequency amplifier consists of 3-stage amplifier with tunable gain, AGC system, linear output buffer for differential analog output, ana...
86
0.0
25 to 1750 MHz power amplifier
055TSMC_PA_03 is power amplifier block in range from 25 to 1750 MHz. The block consists of C-class power amplifier, pre-amplifier, power management un...
87
0.0
25 to 500 MHz LNA with 0.8 dB NF and 19 dB gain
055TSMC_LNA_02 is an electronic amplifier intended to amplify a very low power signal without significantly degrading its SNR. The operating frequency...
88
0.0
Rail to Rail Input and Output Operational Amplifier
The WEAOPSP18RI18RO1F22G is a rail to rail input and rail to rail output folded cascode with rail to rail output gm stage with input offset control ca...
89
0.0
Reference amplifier, with adjustable gm value
Reference amplifier, with adjustable gm value...
90
0.0
Very-low-noise and programmable very-high-gain DC-voltage amplifier with precision offset trimming
The TS_VA_LNDC_X8 comprises the main function dcamp and its companion dcamptrim. The dcamp is a very-low-output-noise-level (604μVRMS max) and 1%-prec...
91
0.0
Wideband LNA with a gain adjustment range from -22 to 20dB
180TSMC_LNA_14 is a IP block which includes a low-noise amplifier (LNA), gain control system and supply voltage controller. The low-noise amplifier is...
92
0.0
High Bandwidth Differential Output Operational Amplifier
The WEAOPDHB18PI18RO12M22G is a High Bandwidth two stage differential pmos input Operational Amplifier with common mode feedback pmos source follower ...
93
0.0
High Bandwidth Differential Output Operational Amplifier
The WEAOPDHB18PI18SFP11M22G is a High Bandwidth one stage differential pmos input Operational Amplifier with common mode feedback pmos source follower...
94
0.0
High Current, Low offset fast Operation Amplifier
The WEAOPSHC18NI18SFP22M22G is a High current, single ended dual stage Miller operational Amplifier. The Amplifer has two outputs, a high impedance (o...
95
0.0
Instrumentation Amplifier
...
96
0.0
Intermediate-frequency amplifier
Intermediate-frequency amplifier consists of 1 stage amplifier with dual (I/Q) differential inputs/outputs, automatic gain control system and output D...
97
0.0
Up to +/-90V low power high-voltage single-ended amplifier
180XFAB_OpAmp_01 is two-stage amplifier. The first (low-voltage) cascade provides pre-amplification and matching of the common-mode component of the s...
98
0.0
Special Purpose Low (Statistical) offset Operation Amplifier
The WEAOPSPLO18PI18RO12M22G is a special purpose low offset buffer for bias generator that provides a buffered ouput for the Temperature Sensor. The O...
99
0.0
Special Purpose Low offset Operational Amplifier
The WEAOPSLO18NI18RO12M22G is a special purpose low offset and low noise opamp. The opamp architecture is two-stage Miller with RC compensation. The o...
100
0.0
Special Purpose Low offset Operational Amplifier
The WEAOPSLOSP18NI18RO12M22G is a special purpose low offset buffer for bias generator that provides a buffered output for the bandgap voltage.The OpA...