Design & Reuse
500 IP
251
1.0
TSMC 0.13um LVDS Transmitter
The LVDS transmitter is designed to support Single Link transmission between Host and Flat Panel Display with up to SXGA+ resolution and Dual Link tra...
252
1.0
CSMC 0.13um USB 1.1 PHY
The USB1.1 PHY is an IP version of USB transceiver designed in standard logic to interface the physical layer of Universal Serial Bus. It receives dat...
253
1.0
GSMC 0.13μm Low Power Process VCC Detector
This IP contains two Voltage Detector (VDT) circuits and a Power-On-Reset (POR) circuit. The voltage detectors monitor the supply voltage of Bus Suppl...
254
1.0
GSMC 0.18um 1.8v POR
The present IP is a Power On Reset (POR) circuit without external resistors or capacitors. Its power supply is 1.8v....
255
1.0
GSMC 0.18um 3.3V Power on Reset
The present Power-On-Reset circuit generates system reset pulses (RST) when the power supplier is from 1.62V to 3.6V. The output signal RST is positiv...
256
1.0
GSMC 0.18um 3.3V Trimming Block
This IP is suitable for voltage trimming. It provides 2 effuse bits, TRIM[1:0]. Before trimming, TRIM[1:0] are set to 1.8V and the output ports are hi...
257
1.0
GSMC 0.18um 3.3v-1.8v Power Regulator
Power Regulator, also called Voltage Regulator, is an on-chip device which provides suitable power supply for the core from an external high voltage p...
258
1.0
GSMC 0.18um 3.3v-1.8v Power Regulator
Power Regulator, also called Voltage Regulator, is an on-chip device which provides suitable power supply for the core from an external high voltage p...
259
1.0
GSMC 0.18um 3.3v-1.8v Power Regulator
Power Regulator, also called Voltage Regulator, is an on-chip device which provides suitable power supply for the core from an external high voltage p...
260
1.0
GSMC 0.18um 3.3v-1.8v Random code generator circuit, internal pattern frequency is 750MHz, sampling clock upto 250MHz.
GSMC18_RCG_03 is to generate random code with the sampling clock up to 250MHz....
261
1.0
GSMC 0.18um 3.3v/1.8v 80mA power regulator
Present project is a regulator that generates 1.8v voltage from 3.3v power supply. Based on the GSMC 0.18um 3.3v process, it provides a maximum curren...
262
1.0
GSMC 0.18um 5v-3.3v Power Regulator
This IP is a Low-Dropout (LDO) 5V to 3.3V power regulator in GSMC 0.18um 3.3V/1.8V Logic process. When it works in regulation region, the max rated ou...
263
1.0
GSMC 0.18um General Process, Low Power circuit design, Diffusion ROM
Based on GSMC 0.13um 1.5V/12V eFlash process, current design of the IP detects light with photodiode. When the incident light power is more than 70mW/...
264
1.0
GSMC 0.18um Power-On Reset
This is a Power-On-Reset circuit that generates a reset pulse when power supply is on. After the power V18 reaches a specific level, i.e., VTR, it wil...
265
1.0
GSMC 0.18um VCC Detector
The present IP is a VCC Detector (VDT) circuit. It detects the voltage level of its power supplies, AV18 and AV33. The normal operation voltage levels...
266
1.0
GSMC 0.18um VCC Detector
The present IP is a VCC Detector (VDT) circuit which detects the core supply and then sends a corresponding control signal to level shift. In specific...
267
1.0
GSMC 0.18um VCC Detector
The present IP is a VCC Detector (VDT) circuit. It detects the battery voltage level. It will generate two flag signals, VBT21 and VBT36, when VBT3 re...
268
1.0
GSMC 0.18um VCC Detector
The present IP is a VCC Detector (VDT) circuit. It detects the voltage level of both core (AVDD18) and I/O (AVDD33). It will generate four flag signal...
269
1.0
GSMC 0.18um Voltage Detector
The present IP is a Voltage Detector (VDT) circuit. Its power supply is 2.7v~3.6v....
270
1.0
GSMC 0.18um Voltage Detector
The present IP devise a Voltage Detector (VDT) circuit. With the help of a 1.2v input reference, it detects both 3.3v and 1.8v input voltages and it w...
271
1.0
GSMC 0.18um Voltage Detector
The present IP is a Voltage Detector (VDT) circuit. When the voltage is in the range of VTHL to VTHH, the output, OUT_RD, is generated as a high level...
272
1.0
GSMC 0.18um Voltage Detector
This IP is a Voltage Detector (VDT) circuit for power management application. When the supply voltage (AVDD33) increases above the detection level (VT...
273
1.0
GSMC 0.18μm 3.3v-1.8v Noise Current Source
GSMC18_NCS_01 is a Noise Current Source IP. It depicts a current consumption block controlled by random code to draw 0mA~3.2mA noise current consumpti...
274
1.0
TSMC 55nm Analog 2-1 MUX
This analog 2-1 MUX is designed for low speed application....
275
1.0
TSMC 65nm Analog 2-1 MUX
This analog 2-1 MUX is designed for low speed application....
276
1.0
CSMC0.13um 3.3V POR
The present IP is a Power On Reset (POR) circuit without any external resistor or capacitor. It supports a power supply range from 2.25V to 3.6V. A CL...
277
1.0
CSMC0.13um VCC Detector
The present IP is a VCC Detector (VDT) circuit. It detects the core supply and gives a control signal to level shift. The IP detects the voltage ...
278
1.0
GSMC0.18um Analog 2-1 MUX
This analog 2 to 1 MUX is designed for low speed application...
279
1.0
GSMC0.18um Analog 2-1 MUX
This analog 2-1 MUX is designed for low speed application....
280
1.0
Dual voltage detector , 3.7V supply - TSMC 180nm
Dual voltage detector , 3.7V supply - TSMC 180nm...
281
1.0
Sub-LVDS receiver followed by 1:4 de-serializer
The S13V25_CCP2RX _01 recovers a serial bit stream containing image data and converts it to a 4-bit 1/4 rate word. The receiver defined in this IP is ...
282
1.0
Buck-Boost Multiple Output Charge Pump
SGC47020_01_TSMC_CV018MH is a multiple output buck-boost charge pump capable of providing 6 different voltage output conversion ratios. Making use of ...
283
1.0
Multiplexer 2x 16 to 1 - XFAB 180nm
Multiplexer 2x 16 to 1 - XFAB 180nm...
284
1.0
Output driver stage for DCDC - TSMC 180nm
Output driver stage for DCDC - TSMC 180nm...
285
1.0
3V-5V Charge Pump for USB OTG
This is a 3V to 5V regulated charge pump that will provide up to 100mA output current. This charge pump mainly targets on the application in USB2.0 OT...
286
1.0
LVDS interface Driver, Fmax 600MHz - XFAB 180nm
LVDS interface Driver, Fmax 600MHz - XFAB 180nm...
287
1.0
LVDS receiver, 650M, 5 channel
The LVDS Receiver IP is designed to support Single Link transmission between Host and Flat Panel Display with up to SXGA+ resolution and Dual Link tra...
288
1.0
Switch SP2T, 2.5GHz - GlobalFoundries 130nm RFSOI
Switch SP2T, 2.5GHz - GlobalFoundries 130nm RFSOI...
289
1.0
Switch with 0/20dB Attenuator
...
290
1.0
Synchronizer, up to 12GHz - GlobalFoundries 40nm
Synchronizer, up to 12GHz - GlobalFoundries 40nm...
291
1.0
Synchronizer, up to 6GHz - GlobalFoundries 55nm
Synchronizer, up to 6GHz - GlobalFoundries 55nm...
292
1.0
Synchronizer, up to 6GHz - STMicroelectronics 65nm
Synchronizer, up to 6GHz - STMicroelectronics 65nm...
293
0.3729
Dolphin process Monitor
The DTI Process Monitor is used to determine how fast delay in silicon is for the current PVT conditions....
294
0.3729
Dolphin Process Voltage Temperature monitor
The DTI Process Monitor is used to determine how fast delay in silicon is for the current PVT conditions....
295
0.118
2 Input Power Switch; UMC 55nm LP/RVT LowK Logic Process
2 Input Power Switch; UMC 55nm LP/RVT LowK Logic Process...
296
0.118
2 port Linear regulator for FXSATA168HD0A ; UMC 90nm SP/RVT LowK Logic Process
2 port Linear regulator for FXSATA168HD0A ; UMC 90nm SP/RVT LowK Logic Process...
297
0.118
4-level detector for USB-OTG applications, input 3.3V; UMC 0.11um eFlash Logic process_x005F_x005F_x005F_x000D_
4-level detector for USB-OTG applications, input 3.3V; UMC 0.11um eFlash Logic process...
298
0.118
4-Level Voltage Detector for USB-OTG ; UMC 28nm HPC Process
4-Level Voltage Detector for USB-OTG ; UMC 28nm HPC Process...
299
0.118
4-Level Voltage Detector for USB-OTG ; UMC 55nm 2.5V overdrive 3.3V device LP/HVT LowK Logic Process _x005F_x005F_x005F_x000D_
4-Level Voltage Detector for USB-OTG ; UMC 55nm 2.5V overdrive 3.3V device LP/HVT LowK Logic Process...
300
0.118
4-Level Voltage Detector for USB-OTG ; UMC 55nm eflash LP/RVT Process
4-Level Voltage Detector for USB-OTG ; UMC 55nm eflash LP/RVT Process...