Design & Reuse
500 IP
451
0.0
Reference Slicer, Differential to Single-Ended
Reference Slicer, Differential to Single-Ended, Idd=1mA, 122.88MHz with div By 2 Option, Floor Noise<-160dBc/Hz...
452
0.0
Temperature sensor
Temperature sensor consists of built-in 10-bit R-2R DAC, diode and own reference voltage former. When requested, controller performs conversion of dio...
453
0.0
Temperature sensor
Temperature sensor consists of built-in 10-bit R-2R DAC, diode and own reference voltage former. When requested, controller performs conversion of dio...
454
0.0
Zero-cross detector and valley OCP block, trimmable
Zero-cross detector and valley OCP block, trimmable...
455
0.0
Levelshifter high-to-low, used in HS driver
Levelshifter high-to-low, used in HS driver...
456
0.0
Levelshifter low-to-high, used in HS driver
Levelshifter low-to-high, used in HS driver...
457
0.0
RF Multiply by 2, 20GHz to 40GHz
RF Multiply by 2, 20GHz to 40GHz, Vdd=800mV, Idd=5mA...
458
0.0
RF Multiply by 2, 40GHz to 80GHz
RF Multiply by 2, 40GHz to 80GHz,VDD=800mV, Idd=5mA...
459
0.0
RF passive mixer
Device is used to transfer incoming useful intermediate-frequency signal (IF) to high frequencies (RF). Quadrature mixer consists of two double balanc...
460
0.0
5GHz RF Buffer
5GHz RF Buffer, Vdd=800mV, Idd=6mA...
461
0.0
Charge pump, makes Vin-3.3V voltage
Charge pump, makes Vin-3.3V voltage...
462
0.0
Phase frequency detector and charge pump
The device consists of phase frequency detector (PFD), charge pump and lock detector (LD). PFD compares phases of a divided VCO signal and a divided...
463
0.0
Phase-frequency detector in CMOS logic
The phase-frequency detector (PFD) consists of a signal level converter from differential reduced swing ECL to single-ended full swing CMOS signal and...
464
0.0
UHF RFID EPC Gen2 physical interface
130GF _G2PHY_02 is the IP intended for use in passive UHF transponder applications. IP derives its operating power from an RF electromagnetic field ge...
465
0.0
Ripple injector
Ripple injector, feedback block for regulator output ripple measurement...
466
0.0
VIS 150nm 5V Bandgap voltage reference
The OT0118 is a medium precision, bandgap voltage reference and current reference generator specifically tuned for the VIS 150nm CMOS process....
467
0.0
Divide by 2
Output divider with glitchless transition between division values...
468
0.0
Divide-by-N, up to 3GHz, Programmanble Division Number
10-bit divider, 3 GHz maximum input frequency...
469
0.0
Divide-By-Two, 40GHz to 20GHz
Div-By-2 MMWave divider, 40GHz to 20GHz, Idd=5mA...
470
0.0
Divide-By-Two, 80GHz to 40GHz
Div-By-2 MMWave divider, 80GHz to 40GHz, Idd=5mA...
471
0.0
Divide-By-Two, Sub 20GHz
Div-By-2 RF divider, Sub 20GHz, Idd=10mA@20GHz...
472
0.0
Clock/Data Recovery PLL
The MXL-PLL-CDR is a clock/data recovery PLL implemented using a digital CMOS process. It is highly integrated and require no external components. Dif...
473
0.0
Analog signal MUX for telemetry purposes, 16:1
Analog signal MUX for telemetry purposes, 16:1 (implemented using 4:1 MUXes)...
474
0.0
Analog signal MUX, 4:1, for on-chip analog signal monitoring
Analog signal MUX, 4:1, for on-chip analog signal monitoring...
475
0.0
Inverter based delay chain, 10ns
Inverter based delay chain, 10ns...
476
0.0
Inverter based delay chain, 5ns
Inverter based delay chain, 5ns...
477
0.0
Lock Detector
Lock detector...
478
0.0
TON timer, provides COT switching time based on Vin and Vout
TON timer, provides COT switching time based on Vin and Vout...
479
0.0
Corrector ADC
This IP provides a DC offset removal at the ADC output, the channel amplitude and phase imbalances cancelation. The corrector is fully parameterized a...
480
0.0
Power on Reset 1.2V
055SMIC_POR_04 provides a reset signal to the chip when supply voltage reach required level. POR generates reset signal depending of the level supply ...
481
0.0
Process/Voltage/Temperature Sensor (Supply voltage 1.8V/0.9V)
028UMC_PVT_01 IP library is a unique solution intended to continuously monitor IC status at several on-die locations. It is able to detect manufactu...
482
0.0
Process/Voltage/Temperature Sensor (Supply voltage 2.5V/1.1V)
PVT Detector is a unique solution intended to continuously monitor IC status at several on-die locations. It is able to detect manufacturing process d...
483
0.0
Process/Voltage/Temperature Sensor (Supply voltage 3.3V/1.1V)
PVT Detector is a unique solution intended to continuously monitor IC status at several on-die locations. It is able to detect manufacturing process d...
484
0.0
Cross-Correlator Matrix 64x64
PMCC_XCM_64x64_D IP block is a low-power array of 1GHz clocked Cross-Correlator cells that are synchronously acquiring two sets of 64x2-bit data strea...
485
0.0
Cross-Correlator With 64x2 Channels
PMCC_XCM_64x64 is an IP block capable of calculating the cross-correlations between 64x2 analog signals supplied to the inputs ARM1 and ARM2. The IP b...
486
0.0
HS bootstrap driver for HS NMOS gate voltage generation
HS bootstrap driver for HS NMOS gate voltage generation...
487
0.0
HS current protection circuit
HS current protection circuit...
488
0.0
HS current replica block, 1:100'000
HS current replica block, 1:100'000, for HS switch current measurement...
489
0.0
LS current replica block, 1:100'000
LS current replica block, 1:100'000, for LS switch current measurement...
490
0.0
HS power switch driver
HS power switch driver...
491
0.0
LS power switch driver
LS power switch driver...
492
0.0
HSSTP Link
The High-Speed Serial Trace Port (HSSTP) Controller IP implements the ARM HSSTP protocol. HSSTP replaces the existing parallel data output port, enabl...
493
0.0
HSSTP PHY TX 5nm (1.5 Gbps, 3 Gbps, and 6 Gbps)
The HSSTP TX PHY is a 5nm hard macro supporting up to 6Gbps data rates with dual lanes and a hybrid mode driver for AC-coupled links. It includes feat...
494
0.0
JTAG 2-Wire to 4-Wire Adapter
The OT4001_cjtag is an adapter which permits legacy IEEE 1149.1 ports to communicate as an IEEE 1149.7 2-wire OScan1 cJTAG port. A simple update to a ...
495
0.0
Quadrature former 1.25-1.9 GHz
Quadrature former (QF) generate differential output signals with phase shift of 90° for each of 4 channel, coherent to input signal. QF has two inputs...
496
0.0
Quadrature former 25-1750MHz
The quadrature former block is intended to generate quadrature signal in frequency range 25-1750MHz with phase correction ±4.The quadrature former co...
497
0.0
Quadrature former 75-750 MHz
This device is designed to generate a quadrature heterodyne (oscillator) signal. CML logic quadrature generator consists of pre-switchable divider wit...
498
0.0
Quadruple Capacitor Switch
The TS_SW_4Cap_X8 is a quadruple capacitor switch that can be used for resonator/transducer trimming. TES can transfer this IP to other technologies u...
499
0.0
Current monitor circuit, Vout=1.2V+0.06V*Iload
Current monitor circuit, Vout=1.2V+0.06V*Iload...
500
0.0
AXI to I2S Bridge for Audio CODEC
AXI to I2S Codec connection. Support for multiple channels. Each channel includes a FIFO accessible from parallel and AXI interfaces....